|
So one day I dug out whole set of already historical
"Modelarz" and "Plany Modelarskie" periodicals and started to browse
through drawings and plans. In the past I had in my mind the list of
ships I wanted to build one day…. ZENIT was also on that list. Finally
in Summer 2005 I started to work on the "keel".
|
|
Last Updated ( Monday, 06 November 2006 )
|
|
Read more...
|
|
|
So having collected all I could have had collected
with most indispensable set of tools i.e. computer, scanner, printer,
scissors and small saw I begun construction works.
To start with old drawings stated the scale 1:50
(1/4" = 1:48), but even without measuring one could have said that
something is wrong. Publisher simply printed the foils as they fit to
the layout without taking care of adjusting plans’ descriptions. On the
other hand what should I expect from drawings that must have been done
some when in 60s.
|
|
Last Updated ( Monday, 06 November 2006 )
|
|
Read more...
|
|
|
Wooden hull is basically done and I am so proud of it! I have never
expected before I could really do it. It was tough but it was not as
bad as I had expected. Important thing here is that during planking, I
did not have to care about how planks were laid next to each other as
all will be covered anyway. Well, I mean I did care but not as much as
I would have if were about to do hull of historic ship and would want
to leave realistic timber visible.
|
|
Last Updated ( Monday, 06 November 2006 )
|
|
Read more...
|
|
|
Main hull
railing was peanuts so far, as it was more or less straight with curves really
only at the stern. Upped deck and the roof were much more complicated. I had to
do railing bit by bit and then soldered all together. This
time I was soldering and painting most of railing on separate stock of timber
not to destroy already painted roof. Anyway coming back to the railing - I used
the same materials i.e. 1x2 mm brass profile, and 1 and 1.2 brass rods.
|
|
Last Updated ( Sunday, 04 May 2008 )
|
|
Read more...
|
|
|
trimmed plank glued to flat deck
Weeks have passed and ZENIT starts to have recognizable shape.
The deck - all know that decks are not flat. How to
bend piece of plywood so it remains oval across and rises in fore and
after decks? There are number of ways to do it, I chose the following:
|
|
Last Updated ( Monday, 06 November 2006 )
|
|
Read more...
|
|
|
|
<< Start < Prev 1 2 3 Next > End >>
|
| Results 31 - 37 of 37 |
